4. Fate of non-metallic fractions
The nature of the materials used to manufacture electronic boards depends on their application. Two commonly encountered compositions are fiberglass reinforced with epoxy resin, and cellulose paper reinforced with phenolic resin.
Xu's group describes the preparation of a plate from the non-metallic residues from printed circuit boards . First, the electronic boards are crushed, then the copper fraction contained is separated by electrostatic...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Fate of non-metallic fractions
Conclusion and outlook
Article included in this offer
"Profession: Local government engineer"
(
83 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Bibliography
- (1) - COLLINS (T.), HAGMANN (M.) - Une initiative de l'ONU en faveur de l'amélioration du recyclage des déchets électroniques. - EMPA (2007). https://www.empa.ch/documents/56164/296590/a592-2007-03-07-fr-01+MM-ewaste.pdf ...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
