1. Locating three bores on a cylinder
The two-dimensional graphic representation of the geometry of the part to be inspected in figure 1 shows dimensional and geometric tolerancing.
1.1 Tolerancing specification
1.1.1 Definition of the reference system
The Euclidean reference system shown in figure 2 is obtained by the union of plane A and cylinder...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Locating three bores on a cylinder
Locating a left shape
Article included in this offer
"Mechanical and dimensional measurements"
(
124 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
