4. Material characterization
Characterization and modeling (part sizing) are closely linked. It is from the analysis of phenomena occurring during use that the characteristics to be measured are determined.
Characterization and therefore sizing are fraught with difficulties.
-
Phenolic materials, whether for ablative and/or insulating use, are composites: as such, they are distinguished from other materials by their anisotropy. The preferred directions of the molded composite according to the arrangements of the fibrous reinforcements are imperatively marked (mark 1, 2 and 3) and remain attached to the composite (figure 3 a).
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Material characterization
Sizing nozzle parts
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Standardization
French Standards Association (AFNOR)
- Reinforced plastics – Moulding composites and prepregs. Determination of apparent volatile matter content. - NF ISO 9782 - 06-1994
- Fiber-reinforced plastics – Prepregs – Determination of the conventional resin flow rate (float) parallel to the plane of the folds. - T 57-603 - 09-1988
- Fiber-reinforced plastics – Prepregs and molding compounds – Determination of resin,...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
