4. Interface delamination
4.1 Physics of mode I and mode II propagation
Now that we've seen how to measure the rate of critical energy restitution in Mode I and Mode II, let's try to understand why these two values are so different. Indeed, if we look at some typical composite values, we can see that mode II toughness is always higher than mode I, and up to 2 to 3 times higher (table 1 ).
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Interface delamination
Conclusion
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
