2. Specific implementation methods
We have seen that most thermoplastics can be filled with short glass or carbon fibers. Polymers intended for technical applications are preferably reinforced in this way: PA, poly(oxymethylene) POM, PAS, (polyarylsulfone), PES (polyethersulfone)... These materials can be injected or extruded using the equipment, tools and techniques normally employed with unfilled plastics, and which are the subject of specialized articles in this treatise.
On the other hand, original techniques have been developed for processing long-fibre composites. The description of these specific methods obviously occupies an important place in the "Composites" section.
2.1 Contact molding
the reader is referred to...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Specific implementation methods
Properties
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
