2. Technical presentation
2.1 Screw production
Screws undergo several machining operations from the raw material bar. The first operation consists of turning the bar to obtain a bar slightly larger (1 mm) than the final diameter of the screw. In the second operation, this bar is then placed on a milling machine to machine the screw channels. This milling machine may be an end mill or a trimming machine. The third operation is to drill the screw, if this is necessary for thermal regulation. The fourth operation is to...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Technical presentation
Troubleshooting
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
