7. Part extraction
The evacuation system is used to remove the article from the mold (figure 5 , 6). The evacuation clamps are installed before the mold is opened (figure 5 , 5). They are temperature-controlled to prevent the material from sticking.
After removal from the mold, the part can be decarotized either manually, by robot, or through a mask that follows the part's geometry. After separation...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Part extraction
Aftercooling
Article included in this offer
"Plastics and composites"
(
329 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
