9. Appendices

9.1 Specific standards for some HDPE applications

The two main control standards (§ 3.1 ) used to distinguish the different grades of HDPE on the basis of their density and melt flow rate at 190°C (MFR) are :

NF EN ISO 1183-1 2004 Plastics – Methods for determining the density of cellular plastics...

You do not have access to this resource.

Exclusive to subscribers. 97% yet to be discovered!

You do not have access to this resource.
Click here to request your free trial access!

Already subscribed? Log in!

The Ultimate Scientific and Technical Reference

A Comprehensive Knowledge Base, with over 1,200 authors and 100 scientific advisors

+ More than 10,000 articles and 1,000 how-to sheets, over 800 new or updated articles every year

From design to prototyping, right through to industrialization, the reference for securing the development of your industrial projects

This article is included in

Plastics and composites

This offer includes:

Knowledge Base

Updated and enriched with articles validated by our scientific committees

Services

A set of exclusive tools to complement the resources

Practical Path

Operational and didactic, to guarantee the acquisition of transversal skills

Doc & Quiz

Interactive articles with quizzes, for constructive reading

Subscribe now!

Ongoing reading
Appendices

Previous
page Acronyms, notations and symbols

Bibliography

(1) - PEACOCK (J.A.) - Handbook of polyethylene – Structure, properties & applications. - Marcel Dekker Inc. (2000).
(2) - GRANN-MEYER (E.) - Polyethylene pipes in applied engineering – Handbook. - Total (2005).
...

Regulations

NF 388 mark – Plastic tanks used for unburied storage of domestic heating oil.

NF 114 mark – Polyethylene pipes for combustible gas distribution networks, drinking water distribution networks, irrigation and industrial applications, non-drinking water and pressurized wastewater systems.