12. Stacker cutter
The plate is only cut to length once cooling is complete, i.e. after the pulling station.
This is done with shears, except for brittle polymers where a circular saw is required.
In all cases, the cutting system is mounted on a table which moves at line speed and returns to the stand-by position once cutting is complete.
The cut sheets are then handled by a handling system equipped with suction cups, which lifts them and stacks them on their pallets.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Stacker cutter
Lamination
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
