4. Tests on flat specimens and bars
4.1 Specimen production
Specimens are either molded directly, cut from sample plates or cut from structures. For thermoset materials, cutting is carried out by milling or sawing with a diamond disk, depending on the case. Sample plates are produced in accordance with :
T 57-151 (unidirectional reinforcement plates for specimens with molded heels) ;
NF ISO 9291 (flat wound plates with unidirectional reinforcement) ;
NF T 57-153 (plates with fabric and/or mat reinforcements) ;
T 57-300 (carbon fabric-reinforced sheets and prepregs, press-molded, bag-molded or autoclaved) ;
NF ISO 9353 (T 57-154) (Unidirectional...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Tests on flat specimens and bars
Tube and ring testing
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
