Overview
ABSTRACT
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHORS
-
Pierre MOUSSEAU : Senior lecturer at Nantes University Institute of Technology
-
Alain SARDA : Senior Lecturer - Head of the Materials Science and Engineering Department at Nantes IUT
-
Rémi DETERRE : University Professor - Director of the OPERP laboratory – IUT de Nantes
INTRODUCTION
The thermal phenomena involved in the molding cycle were presented in the dossier: "Thermal injection of thermoplastics. Fundamentals". In this second dossier, we present notions of optimization and control of thermal phenomena: optimal filling time, notions of thermal control of tools (stability and homogeneity) and optimal cooling time of molded parts. Many of the results are based on concepts developed in . The variables and parameters used are defined in the following table.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Thermal injection of thermoplastics. Optimization
Optimizing cooling of injection-molded parts
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Also in our database
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
