1. Predimensioning calculation
A table summarizing ratings and symbols can be consulted at the end of the file.
Before starting up a toothed belt system, an overall preload F 0 must be applied in order to subsequently ensure power transmission without causing tooth skipping ( § 1 and § 1.3). Then, during operation, the occurrence of driving T r and resisting T n torques produces tension differences in the belt's straight strands (figure 1 ), respectively F 1 in the taut strand and F 2 in the slack...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Predimensioning calculation
Quasi-static load distribution on belt teeth
Article included in this offer
"Mechanical functions and components"
(
212 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
