Overview
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHOR
-
Denis DUFOURNET : Senior Member of the Society of Electrical and Electronics Engineers (SEE) and the American Institute of Electrical and Electronics Engineers (IEEE)
INTRODUCTION
In this booklet, we provide calculations for determining the voltage restored at the break of each pole in the case of a three-phase terminal fault, and the three-phase, two-phase and single-phase terminal fault currents. The form of the recovery transient voltage for a near-line fault is also determined, and the form of the recovery transient voltage for a terminal fault is explained.
The article "High-voltage alternating-current switchgear" is the subject of several fascicles:
Part 1: General. Classifications. Characterization.
Part 2: Basic problems. Switching currents on and off.
Part 3: Presentation of equipment. Type and individual tests.
[D 4 696] Appendices.
The subjects are not independent of each other. Readers will often need to refer to other issues.
The article deals with "Interruption of DC circuits".
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
HV electrical switchgear. Appendices
Voltage restored in the event of a three-phase terminal fault
Article included in this offer
"Electricity networks and applications"
(
186 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Reference documents
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
