Overview
ABSTRACT
The horizontal force produced by the air flow on the wind turbine blades generates an overturning moment at the mast base. The geotechnical foundation design of onshore wind turbines is based on the tilting criteria compliance. Controlling the sole peel-off results in requirements for the diameter, mass and anchoring depth depending on the load cases and buoyancy pressure. The type of foundation depends on the soil bearing capacity and its deformability.
The article presents the different possible foundation modes: superficial slab, with or without ground improvement, or deep foundations.
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHORS
-
Eric ANTOINET : Technical Manager Infrastructure - Antea Group, Olivet, France
-
Maxime MARTHE : Head of Wind Turbine France - Antea Group, Lille, France
INTRODUCTION
Over the past twenty years, some 9,000 onshore wind turbines have been built in France, in 1,400 wind farms. New wind turbines are expected to be built at a rate of between 600 and 700 a year over the next few years.
This article deals with the geotechnical issues associated with the design and construction of foundations for horizontal-axis wind turbines (figure 1 in direction F HE ), located on land.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
KEYWORDS
geotechnical engineering | wind turbine | foundations | onshore wind turbine
Onshore wind turbine foundations
General information on onshore wind power in France
Article included in this offer
"Soil mechanics and geotechnics"
(
42 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
