4. Sizing of retaining walls and anchors – Standard NF P 94-282
4.1 Application
Standard NF P 94-282 complements Eurocode 7 for the design and dimensioning of retaining walls and anchors. It is also based on a number of execution standards resulting from the work of the TC288 :
NF EN 1537 standard for tie rods;
NF EN 1538 standard for cast walls;
standard NF EN 12063 for sheet piling.
In addition, an amendment A1 modifying or clarifying certain requirements or recommendations has been added.
As there were no existing documents or recommendations for the justification of retaining walls, the NF P 94-282 standard reflects the consensus of various national practices, both in...
The Ultimate Scientific and Technical Reference
This article is included in
Soil mechanics and geotechnics
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Sizing of retaining walls and anchors – Standard NF P 94-282
Dimensioning retaining walls – Standard NF P 94-281
Bibliography
Websites
-
CFMS – Comité Français de Mécanique des Sols Documentation Normes et Recommandations Internet
http://www.cfms-sols.org/documentation/normes-et-recommandations (page consulted on January 5, 2015)
-
CNJOG – Commission...
Standards and norms
- Fondations superficielles Norme NF DTU P 11-211. - DTU 13.11 - 1988
- Règles pour le calcul des fondations superficielles Norme NF DTU P 11-711. - DTU 13.12 - 1988
- Travaux de fondations profondes pour le bâtiment Norme NF DTU P 11-212. - DTU 13.2 - 1992
- Geotechnical calculations – Part 1: General rules, EN 1997-1 European Committee for Standardization (CEN), Brussels. - Eurocode 7 – Partie 1 (NF EN 1997-1)...
The Ultimate Scientific and Technical Reference
