8. Door manufacturing
This section deals exclusively with interior doors or flat doors, the most important market for adhesives.
These doors are made up of :
wooden frames assembled at all 4 corners using mortise and tenon joints or glued dowels;
honeycomb cores made of cardboard or wooden laths with, optionally, a polyurethane foam core;
various facings: thin plywood or wood-fibre panels, possibly with decorative coatings such as wood veneers or laminates.
-
Assembling frames and gluing faces to cores and frames
In Europe, interior doors are almost always manufactured in very large series. In fact, 5 to 10 doors are used per home, a figure that must be multiplied by the 400,000 homes built...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Door manufacturing
Window manufacturing
Article included in this offer
"Wood and paper"
(
55 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Standardization
French Standards Association (AFNOR)
http://www.afnor.org
- Wood-based panels – Determination of formaldehyde content – Extraction method, also known as the perforator method. - NF EN 120 - 10-92
- Classification des colles thermoplastiques pour bois à usages non structuraux. - NF EN 204 - 04-02
- Thin, long and oriented strand board (OSB) – Definitions, classification and requirements....
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
