6. Panelling and battens
Large, flat panels are manufactured from wooden slats glued along their long sides. In this way, either decorative panels (figure
19
) or slatted panels, such as those shown in figures 6b and c of the
Special machines called lathing or panelling machines are used for this purpose.
This technique offers two major advantages:
it offers the possibility of making large panels from slats of small square cross-section, from 2 × 2 to 5 × 5 cm, which makes it possible to recover small trees and slabs...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Panelling and battens
High frequency and microwaves
Article included in this offer
"Wood and paper"
(
55 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Standardization
French Standards Association (AFNOR)
http://www.afnor.org
- Wood-based panels – Determination of formaldehyde content – Extraction method, also known as the perforator method. - NF EN 120 - 10-92
- Classification des colles thermoplastiques pour bois à usages non structuraux. - NF EN 204 - 04-02
- Thin, long and oriented strand board (OSB) – Definitions, classification and requirements....
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
