2. Using injection molding machines: adjustment
2.1 Injection cycle
The cycle sequence includes mold closing and locking, followed by pontoon support, melt injection and holding, part cooling and dosing in masked time, mold opening and part ejection.
When the mold is closed, locked and the pontoon is supported, the screw position is the same as at the end of dosing or at the end of suction, plus a possible displacement caused by material expansion due to heating or decompression.
The position of...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Using injection molding machines: adjustment
Understanding and solving quality problems
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
