1. Experimental development of IDI diesel engines
1.1 Pre-definition of injection system on electric test bench
See also J.L. Froment's article [BM 2 585] Diesel engines: injection and combustion chamber (ref. [6]).
The aim is to select the injection pump and injectors that will :
inject the required flow at full load for an injection time that must not be excessive (do not exceed 35 to 40 crankshaft degrees), otherwise there is a risk of reduced efficiency and increased smoke;
inject for as long as possible at idle to reduce noise;
optimize the rate of introduction (the rate of introduction is the instantaneous flow rate injected, in cm...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Experimental development of IDI diesel engines
Experimental development of DI diesel engines
Article included in this offer
"Hydraulic, aerodynamic and thermal machines"
(
177 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
