Overview
ABSTRACT
Beam in flexure modeling is one approach of the modeling of preconstraint assemblies with a single bolt. It allows for dealing with assemblies of low thickness compared with other dimensions and to which the VDI modeling cannot be applied. Accurately implemented, it reflects the non-linear behavior of the bond under the action of an external load and allows for the fatigue calculation of the assembly component and the optimization of the value of the prestress force to be installed.
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHOR
-
Jean GUILLOT : Professor Emeritus - Institut national des Sciences Appliquées de TOULOUSE (INSAT)
INTRODUCTION
This second part presents another approach to modeling prestressed single-bolt connections: flexural beam modeling. This allows us to deal with connections whose thickness is small compared with other dimensions, and for which VDI modeling is no longer applicable.
Correctly applied, it accurately reflects the non-linear behavior of the connection under the action of an external load, and enables fatigue calculation of the connecting element and optimization of the value of the prestressing to be installed.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Calculation of screwed assemblies
Introduction to flexural beam modeling
Article included in this offer
"Mechanical functions and components"
(
212 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
