2. Strength calculations for parallel gears
2.1 Standardization
The ISO TC 60 Committee has defined methods for calculating tooth strength. The original documents are as follows.
A. General methods – Parallel gears :
ISO/DIS 6336. Calculation of the load capacity of spur and helical parallel gears.
Part 1: Basic principles, introduction and general influencing factors ;
Part 2: Calculation of surface resistance (pitting) ;
Part 3: Calculating the bending strength of tooth roots ;
Part 4: Calculation of gear resistance to galling ;
Part 5: Strength and quality of materials.
B. Specific application methods for industrial gears....
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Strength calculations for parallel gears
Strength calculations for meshing gears and worm gears
Article included in this offer
"Mechanical functions and components"
(
212 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
