3. Experimental results
3.1 Elastic return
Controlling the geometry of flat product parts has always posed problems in the industrial environment. The phenomenon of springback (figure 22 ) is often associated with material properties; however, process control is easier by acting on process parameters than on sheet properties.
The factors already mentioned, particularly those associated with material production and design, have an impact not only on the mechanical quality of the product, but also on its geometry. Shape error can therefore depend on three distinct sets of factors:
material properties: elasticity,...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Experimental results
Conclusion
Article included in this offer
"Material processing - Assembly"
(
174 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
