2. Weldability standards specific to aerospace construction
Standard NF L06-380, applicable to materials used in aerospace construction, defines the degrees of weldability and brazeability of these materials for welding and brazing processes and techniques.
Part 10 deals with the definition of the degree of weldability or solderability and the rules for determining it. The weldability of materials is assessed according to four degrees defined below:
grade 1: material with very good weldability requiring no special precautions. Preferred use;
grade 2: material with good weldability, but which may require special welding precautions (e.g. preheating, low feed rate, etc.);
grade 3: material with poor weldability requiring fine-tuning for each type of part and likely to lead to manufacturing hazards. Not recommended;...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Weldability standards specific to aerospace construction
Cold compressor rotors
Article included in this offer
"Material processing - Assembly"
(
174 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
