1. Special conditions of use for milling inserts
The notations used in this article are defined in the "Notations and symbols" table at the beginning of the article. . Refer to it if necessary.
1.1 Use of round inserts in milling
The angle of attack of a milling cutter has a decisive influence on cutting performance, which depends on the angle at which the cutting edge meets the workpiece, the action of the cutting forces and the pressure distribution over the entire length of the cutting edge. The difference between 90° face milling cutters and 45° cutters for general face milling and cast iron has been discussed in previous articles in this section, as have cutters with 75° or 60° rake angles. We have not, however, looked at the effect of rake angle...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Special conditions of use for milling inserts
Special milling applications
Article included in this offer
"Material processing - Assembly"
(
174 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
