3. Defects in rolled products
Surface defects observed on rolled products can be classified into three main categories:
defects due to incorrect adjustment of the train;
defects appearing during rolling;
defects originating from the ingots.
These defects may be combined on the same ingot. To prevent them from being transferred to the wire drawing mill, the billets are inspected and repaired during finishing.
3.1 Defects due to incorrect wheel alignment
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Defects in rolled products
Conclusion
Article included in this offer
"Metal manufacturing processes and recycling"
(
121 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
