7. Mistakes to avoid
7.1 Failure to integrate existing safety barriers into the risk analysis from the outset
Checking the level of risk present in your facilities "as is", according to the products, processes and equipment as well as the configuration of the workplaces, and then subsequently integrating the safety barriers, makes it possible to :
a better understanding of the intrinsic risks of its site;
facilitate the choice of priorities for action on the changes to be made to reduce these risks;
justify and verify the effectiveness and usefulness of existing or future safety barriers;
be in a position to choose the most appropriate actions for your...
The Ultimate Scientific and Technical Reference
This article is included in
Environment manager
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Mistakes to avoid
Frequently asked questions
Bibliography
Guide méthodologique national du 25 juin 2003 , based on the INERIS model, version 1, dated May 20, 2003 " Outils d'analyse des risques générés par une installation industrielle ".
Circular dated 10/05/10 summarizing the methodological rules applicable to hazard studies, risk reduction at source and technological risk prevention plans (PPRT) for classified facilities,...
Downloadable tools
ToolAnalysis methods (Tool ...
Regulations
-
comprising a Legislative section, a Regulatory section and an Appendices section, which includes the ICPE nomenclature (in particular Article R. 512-33 of the Environment Code, which specifies the cases in which a hazard study must...
The Ultimate Scientific and Technical Reference
