7. Mistakes to avoid
7.1 Do not increase temperature and pressure
Don't think that increasing pressure or penetration will improve the strength of your weld. On the contrary, all experience shows that pressure should remain between 2.5 and 3.5 bar. This applies to all welding technologies (even manual).
SCROLL TO TOP7.2 Don't overheat materials, as this will damage them
If you combine high temperature (without degrading the material) and high pressure, the welding resistance decreases.
The Ultimate Scientific and Technical Reference
This article is included in
Design and engineering management
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Mistakes to avoid
Abbreviations and acronyms
Bibliography
Célia NICODEAU's thesis "Modelling the continuous welding of thermoplastic matrix composites" - 2005
Thesis by François LEMARCHAND "Study of the occurrence of residual stresses in the welding stacking process and continuous consolidation of thermoplastic composites" - 2008
Jean-Florent LAMETRE's thesis "Study of the adhesion of semi-crystalline...
Products and suppliers
3454 route de Saint-Amour – Grande Belle Vavre – 01340 Foissiat (France)
Tel.: 04 74 22 45 41
Rabenhof 18a - 33609 Bielefeld (Germany)
Tel.:...
The Ultimate Scientific and Technical Reference
