7. Our advice
7.1 Ask production to remove burrs from the parting line
Don't think that adjusting the machine's parameters will remove burrs from your workpieces; at most, you'll be able to reduce them.
Vibration welds are generally very coarse, and only the design of the parting line can mask the weld and its burrs.
If the aesthetics of the weld is an important factor, review the design of your part as a priority.
SCROLL TO TOP
The Ultimate Scientific and Technical Reference
This article is included in
Design and engineering management
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Our advice
Mistakes to avoid
ToolProducts and suppliers
3454 route de Saint-Amour – Grande Belle Vavre – 01340 Foissiat (France)
Tel.: 04 74 22 45 41
234, Rue Georges-Charpak – Technosite Altéa – Mécasonic, 74100 Juvigny (France)...
The Ultimate Scientific and Technical Reference
