2. Definition of control terms
2.1 Identification of the position of the gap in question
It's convenient to identify the deviations corresponding to the measurements made using specific references to individual right and left flanks, pitches or combinations of these elements.
In the following, conventions are given for determining the position of positive gaps.
SCROLL TO TOPIt's convenient to choose one side of the wheel as the reference side and mark it with the Roman numeral I. The...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Definition of control terms
Tolerance values
Article included in this offer
"Mechanical and dimensional measurements"
(
124 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
- HENRIOT (G.) - Engrenages. Conception, fabrication, mise en œuvre. - 1999 Dunod - Engrenages : définition, éléments pour la fabrication, contrôle, tables d'involutes. CETIM (Centre technique des industries mécaniques) ouvrage collectif (1998).
Standardization
French and European...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
