Overview
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHOR
-
Michel PASQUIER : Engineer from École Supérieure de l'Énergie et des Matériaux - CMD Gears and Reducers
INTRODUCTION
The tolerance system we will develop in this article complies with NF ISO 1328 standards and FD ISO/TR10064 technical reports from ISO technical committee 60 "Gears".
It applies only to cylindrical gears with involute profile teeth, and is limited to wheels with a diameter of 10,000 mm and a module of 70 mm.
Permissible deviations will be indicated by formulas (used for computer programs).
The system's reference rack is that of standard NF ISO 54.
This system specifies all the deviations that can be checked on an individual wheel or a complete gear, with the corresponding tolerances.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Parallel gear control
Wheel housing check
Article included in this offer
"Mechanical and dimensional measurements"
(
124 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
- HENRIOT (G.) - Engrenages. Conception, fabrication, mise en œuvre. - 1999 Dunod - Engrenages : définition, éléments pour la fabrication, contrôle, tables d'involutes. CETIM (Centre technique des industries mécaniques) ouvrage collectif (1998).
Standardization
French and European...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
