3. Connection of surface finish measurement results
3.1 Standards
The calibration of instruments in their various operating modes requires several types of standards. Each of these standards has a limited field of application depending on its characteristics (table 10 ).
Table 11 describes the various standards defined by standardization.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Connection of surface finish measurement results
Topography
Article included in this offer
"Mechanical and dimensional measurements"
(
124 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
- CNOMO - Guide de capitalisation pour la caractérisation et la mesure des états de surface en complément de la normalisation ISO. - GE40-084N, nov. 2000. http://www.cnomo.com
- Dr BLUNT (L.) -...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
