1. Surface finish measurements
1.1 Parameter estimation
The item to be measured has :
homogeneous zones: the values determined over the entire surface are to be used for comparison with the requirements;
non-homogeneous zones: the parameter values determined for each of these zones must be used separately for comparison with the requirements.
When requirements are specified by the upper limit of the parameter, use the area or areas of the surface that appear to have the maximum value of the parameter.
If the direction is not specified, the part must be positioned so that the direction of the section corresponds to the maximum values of the surface roughness height parameters....
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Surface finish measurements
Surface finish measurement equipment
Article included in this offer
"Mechanical and dimensional measurements"
(
124 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
- CNOMO - Guide de capitalisation pour la caractérisation et la mesure des états de surface en complément de la normalisation ISO. - GE40-084N, nov. 2000. http://www.cnomo.com
- Dr BLUNT (L.) -...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
