6. Simulation, other transformation processes
6.1 Simulation
Simulating the filling and cooling of microplasturgy parts is perfectly feasible with the best software on the market, as today's computers allow high-precision calculations. However, certain rules must be observed:
no compromise on geometric details (ribs, fillets) and thicknesses (especially draft);
imperative modeling of the feed channel (due to the part mass/molded mass ratio) ;
influence of cooling channels considered negligible (part/mould ratio) ;
strict monitoring of the shear stresses applied to the polymer.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Simulation, other transformation processes
Article included in this offer
"Plastics and composites"
(
356 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Works
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
