5. Demolding
During demolding, the part is released from the mold so that it can be ejected.
Injected parts are held in the mold not only by their thermal contraction, which causes them to be clamped onto the core(s) during cooling, but also by their undercuts (surfaces of the part that resist demolding) or lateral orifices, which immobilize them. Mechanical solutions enable parts with such holes or undercuts to be demolded.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Demolding
Ejection system
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
