6. Causes of problems and corrective actions
6.1 General rules
When a problem is detected, it is customary to apply the solution (table 5 ):
Precise location and identification of the problem by answering the questions: what, how, when, where (temporary, local).
On-site verification of parameters (avoid sending samples to the laboratory as much as possible).
Based on the results, compile a list of probable causes.
If necessary, conduct a thorough laboratory test to identify the cause(s).
Preparation of measures and implementation.
Validation of effectiveness....
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Causes of problems and corrective actions
Filtration
Article included in this offer
"Material processing - Assembly"
(
174 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
