1. General
1.1 Definitions
-
Thin sheet metal stamping is usually carried out on double-acting presses (see article on Presses
[B 7 570] a punch on which the metal is bent and stretched;
a die to support the metal, which can sometimes be a counter-form (at least partial) to the punch;
a sheet clamp to hold the sheet in place and slow the flow of metal into the die.
The metal to be stamped can be either in coil form (continuous...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
General
Range design stages
Article included in this offer
"Material processing - Assembly"
(
174 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
