2. Range design stages
Designing the stamping line involves a number of steps, which we'll follow step by step.
2.1 Geometric definition of the part
Stamping rarely produces the part defined by the design office directly. It is generally necessary to produce a derivative part capable of the desired geometry, i.e. one into which this geometry will be cut during the routing process. What's more, several additional operations are often required to obtain secondary details to the stamping operation itself (edge dropping or raising, necking, detail stamping, etc.).
The first step, therefore, is to start with the Études part, reshape it in its peripheral areas and complete it with additional surfaces (or trim), to end up with a more balanced Méthodes part that can...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Range design stages
Tools
Article included in this offer
"Material processing - Assembly"
(
174 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
