Overview
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHOR
-
François BERNOT : Engineer from École Supérieure d'Électricité - Doctor of Engineering Sciences - Senior lecturer at UTBM (Belfort)
INTRODUCTION
This article is the logical continuation of the section on the construction and operation of DC machines. The following presentation, much more technological than the previous one, is divided into several distinct parts.
It begins with armature design techniques, followed by the inductor. Auxiliary poles are then discussed, followed by various dimensioning elements. Techniques specific to wound and magnet inductors are presented in the text as required. A general overview of the questions facing the designer is presented, without detailing every aspect of machine design.
this article is a partial co-edition of one of the chapters in the author's book: La vitesse variable électrique, motovariateurs à courant direct
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
DC machines - Construction
General
Article included in this offer
"Conversion of electrical energy"
(
278 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
