6. Checking gauges
In order to meet the checking fixture control requirements defined by quality standards, limit gauges must be checked. Verification intervals depend on the user's requirements and must be adapted to the conditions under which the gauges are used.
6.1 Size tolerances
The dimensional and geometric tolerances of plain gauges are determined in accordance with standard NF E 02-200 and defined by standards NF E 02-202 for "Manufacturing" gauges and NF E 02-205 for "Reception" gauges.
SCROLL TO TOP
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Checking gauges
Appendix: calculation of thermal stabilization times
Article included in this offer
"Mechanical and dimensional measurements"
(
124 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Standardization
French standards
Association Française de Normalisation (AFNOR): http://www.afnor.fr
- Système ISO de tolérances et d'ajustements - Partie 1 : base des tolérances, écarts et ajustements (identique ISO 286-1). - NF EN 20286-1 - 12.93
- Système ISO de tolérances et d'ajustements - Partie 2 : tables des degrés de tolérance normalisés et des écarts limites des alésages et des arbres (identique ISO 286-2)....
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
