3. Taylor's principle
3.1 Interpreting the Taylor principle
It was an English engineer, William Taylor, who filed a patent on September 30, 1905 for the control of screws by gages, who came up with the idea of using a system of Between and Not Between gages.
This system, known as the "Taylor principle", has been extended and applied to limit gauge verification of all smooth, splined, etc., fits.
This principle can be interpreted as follows:
The maximum material condition of an element of a part must be verified by a full-form Between gauge (figure 9 a ), executed at the maximum material limit of this element.
...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Taylor's principle
Limit gauges
Article included in this offer
"Mechanical and dimensional measurements"
(
124 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Standardization
French standards
Association Française de Normalisation (AFNOR): http://www.afnor.fr
- Système ISO de tolérances et d'ajustements - Partie 1 : base des tolérances, écarts et ajustements (identique ISO 286-1). - NF EN 20286-1 - 12.93
- Système ISO de tolérances et d'ajustements - Partie 2 : tables des degrés de tolérance normalisés et des écarts limites des alésages et des arbres (identique ISO 286-2)....
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
