Overview
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHOR
-
Jean‐Louis CHARRON : Engineer at the Centre technique des industries mécaniques (CETIM)
INTRODUCTION
These optical methods of non-contact dimensional measurement generally lead to the production of low-cost sensors. They are widely used in mechanical engineering, where they can be found in the form of simple all-or-nothing sensors used to automate machines, or, at higher cost, in the form of simple one-dimensional measuring sensors. The most complex systems enable three-dimensional measurements. In most cases, they are simple to implement and their operating principle is never very complex.
This article is part of a series devoted to non-contact dimensional measurement sensors:
Non-contact measurement. General ;
Non-contact measurement. Magnetic and capacitive methods ;
Non-contact measurement. Optical methods (part 1) [R 1 332] ;
Non-contact measurement. Optical methods (part 2) ;
Non-contact measurement. Other methods ;
— Non-contact measurement. Comparison for a list of major sensor suppliers.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Non-contact measurement — Optical methods (part 1)
Sources and detectors: general information
Article included in this offer
"Mechanical and dimensional measurements"
(
124 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
