Overview
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHOR
-
Jean-Louis CHARRON : Engineer at the Centre technique des industries mécaniques (CETIM)
INTRODUCTION
Sensors and non-contact dimensional measurement methods are many and varied. These methods are characterized by their measurement range, the type of part they measure, measurement speed and distance, resolution and accuracy. These are the parameters that guide the engineer's choice when faced with a distance or displacement measurement problem.
Data is constantly evolving, particularly in terms of the speed with which profiles, shapes and surface conditions can be measured, where the rapid improvement and cost reduction of IT resources means that sensor data can be processed ever more rapidly and in ever greater quantities.
The values shown represent the state of the art for ECUs mainly equipped with 200 MHz clocks.
This article provides a comparison and non-exhaustive lists of suppliers of the measurement methods presented in the articles :
Non-contact measurement. General ;
Non-contact measurement. Magnetic and capacitive methods ;
Non-contact measurement. Optical methods (part 1) ;
Non-contact measurement. Optical methods (part 2) ;
Non-contact measurements. Other methods [R 1 334] ;
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Non-contact measurement
Methods for measuring profiles, shapes and surface conditions
Article included in this offer
"Mechanical and dimensional measurements"
(
124 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
