2. Spindle design study
The first step is to study the design of the spindle drive and guide system defined by the overall drawing in document 1 (figure 15 , page 14). The data characterizing the spindle are as follows:
Rear bearing consisting of two angular contact ball bearings (B7020E.T.P4S.UL according to FAG), contact angle: α ≥ 25°.
Front bearing composed of three angular contact ball bearings (B7022E.T.P4S.UL according to FAG), contact angle: α ≥ 25°.
-
Pulley :
pitch diameter: D p ≥ 220 mm
...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Spindle design study
Spindle shaft manufacturing study
Article included in this offer
"Material processing - Assembly"
(
174 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
