1. Tool actions on the spindle
The aim of this section is to determine the forces applied by the tool to the workpiece attached to the spindle during a turning operation (figure 1 ).
p : infeed depth (mm)
γ : orthogonal cutting angle
f : feed rate (mm/rev)
α: orthogonal draft angle
h : cutting thickness (mm)
r ∊; : tool nose radius (mm)
b : cutting width (mm)
κ r : edge direction angle
1.1 Cutting...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Tool actions on the spindle
Spindle design study
Article included in this offer
"Material processing - Assembly"
(
174 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
