6. Thickness control
Laminated thickness must be as even as possible. In all cases, it is essential to monitor the thickness during the operation and react to keep it within the desired tolerances. For some thirty years now, all cold rolling mills and most hot finishing mills have been equipped with thickness control, which implies :
to have a means of measuring thickness instantaneously, with good accuracy, and to have it available in the form of an electrical or digital signal;
know the various parameters that can influence product thickness during lamination, and select the parameter(s) to be acted upon to correct any deviations detected.
6.1 Thickness measurement
The most widely used...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Thickness control
Conclusion
Article included in this offer
"Electricity networks and applications"
(
186 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
